Jump to content

JJH

Members
  • Content Count

    117
  • Joined

  • Last visited

Community Reputation

0 Neutral

About JJH

Contact Methods

  • Website URL
    http://
  • ICQ
    0

Profile Information

  • Gender
    Male
  • Location
    UK
  1. Are these a UK based company Owen?
  2. Hi guys, just wondering if you had to choose a diy power hammer which one would you choose and why? Frankenhammer Build Manual https://www.amazon.co.uk/dp/1502928728/ref=cm_sw_r_cp_apa_i_GFprDbQ516T6M Or perhaps another design I haven't seen. Thanks
  3. I'm going through the same thoughts at the moment, I have a simple recipe used in the gingery book, it's just fire clay, grog, and potash feldspar as a flux, the problem comes with firing them properly, I was talking to a guy whose played around and with a home made rig he has a 50%/50% success rate, he also tried the refractory he had left over and that was too insulating so his cast iron didn't fully melt, I'm thinking of teasing out some kaowool and mixing that in in the clay to help. The advantage of home made crucibles is that you can shape the how you want so you'd end up with a more forgable shape
  4. Castable refractory is the most rugged lining material I use 1700c in my furnace 1 1/2" thick with a 2" gap with vermicultie, the bottom is droppable if you get a crucible break, if I were to do it again I'd skip the vermiculite, and use fibre board for forge linings instead, if you can afford it the for "The Artful Bodgers Waste Oil Foundry" by Colin Peck his design is innovative and he's built several furnaces the culmination of these builds and years of experience is in the book a good read!
  5. Amazing temper colours, sorry I missed it, though am finding out what a pita that stuff is like to forge into a proper steel keep up the good work guys
  6. I know the Whitechapel bell founders in London used to use willow rods to stir the bronze melt, it was later discovered that the salicylic acid in the willow bark acted to de oxygenate the melt the same may be true of copper so I guess you could chuck a couple of aspirin in
  7. JJH

    Welding Tangs

    Does anyone scarf then fireweld tangs on as a traditional blacksmith would have. I've done a lot of forge welding and struggle to make the scarves invisible so tips are welcome too
  8. This may be of interest http://www.bladesmithsforum.com/index.php?sh...er+quench\]
  9. Hi Dmitry, Have bought the book and assembled the parts for the furnace need the time to build it now. What is your mix I have the gingery book on making crucibles, and his mix is 38% Fireclay, 2% Potash Feldspa, and 60% 20 mesh Brick Grog. Ant guesses to haw it may perform? Thanks John
  10. Hi Dmitry, can I ask how and what you made your crucibles from? Cheers John
  11. you could use a piece of flattened scaffold pole was shown that and you can cut it to a height most suited to you not dictated by vice or anvil
  12. In these situations a press is better if you've got one I go and use a mates a vice does in a pinch
  13. Some good hints and tips here http://www.knifenetwork.com/forum/showthread.php?t=46184
  14. Does the grade of wrought iron matter I've some cheap hurdle bar which has to be worked at a low welding heat otherwise it can crack would it be suitable?
×
×
  • Create New...