-
Content Count
143 -
Joined
-
Last visited
Community Reputation
2 NeutralProfile Information
-
Gender
Male
-
Location
NE, Georgia
-
Interests
Bladesmithing and Blacksmithing
-
Congratulations on your win. Well done, sir.
-
Advise on doing real work on a tiny anvil
Donnie replied to Anthony Reid's topic in Tools and Tool Making
I have a couple London Pattern anvils. My favorite anvil and the one I use, is a 4'x4' stump anvil from, Old World Anvils. For a while I even used a 12" piece of 1 1/4" square seated in a hole in a stump, just for the heck of it. I don't use the horn or bottom tools, just hammer and anvil. So, for me, all that is used is the hammer face and about the same area of an anvil. To each their own, but as previously mentioned, there has been an awful lot of ironwork produced throughout history on anvils no bigger than a mans fist. -
What size antler do you need?
-
Take care of you and yours. Hope it's not too bad.
-
Top shelf work, as always.
-
I buried my wife on January 11, of this year. She was my whole world. I wish there were some words that could ease your pain. Make the most of every moment.
-
So much for excuses!!!!
-
Nice work.
-
As usual, Alan was right again. Well done, sir. And Thanks for posting.
-
Television. Enough said.
-
Non-Blade: Avil Stand Concept as Coffee Table.
Donnie replied to Dave Stephens's topic in Show and Tell
Well done, sir. -
I like the look of the knife a lot. I've never forged anything from a ball bearing, tough stuff I'm sure. The coin rings are fun to make.
-
Probably the most silly forging information ever
Donnie replied to Sveinn Kallinen's topic in Fiery Beards
Mr. Boggs, is right folks. -
That's something, I have never thought of. Looks good. I like it a lot. Well done, sir.
-
Well done. Best folder I have ever seen.