Jump to content

shaun

Members
  • Content Count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral

Profile Information

  • Gender
    Male
  1. This site should be helpful in making your Fuigo http://www.twinoaksforge.com/BLADSMITHING/BOX%20BELLOWS.HTM
  2. This only works once you have a good covering of fine rust.The more even the covering the better the result. To help with blackening of the steel add a medium amount of tea leaves to the water and simmer it, not boil it, until the rust (red iron oxide) turns black. You will need to seal the metal with a wax or oil to prevent the black powder from rubbing off on your hands as you handle it though. Once sealed it is permenant. shaun
  3. Thanks Walter, I would like to take some close ups of the blade, hamon etc but I'm afraid I just can't seem to get the lighting right. Should I take the pic during the day or night, with or without the flash. All the ones I've taken end up all blurry or don't show the affects of the hamon.......can you give me some tips ? Cheers Shaun
  4. Daniel, thankyou for your kind comments. The ingredience I used are water, salt ,hydrogen peroxide, a small amount of citric acid and a tea spoon of potassium persulphate. I mixed them together and using an old cooking wok on a BBQ burner to heat the mix. I suspended the tsuba above the solution put on the glass lid and periodicly heated it over 3 days then neutralized the rusting and then immersed it in very hot but not boiling japanese green tea for one hour then waxed it. Robert, Thanks for the welcome, I look forward to learning and sharing ideas Chears Shaun
  5. This is my first sword blade project a Tanto in Hira-Zukuri profile. The theme for this blade is a bamboo and I made everything myself except the fuchi, kasira and ito. The blade is a big one as far as Tanto's go, it has a cutting edge of 300mm and is 5mm thick at the Habaki, the steel I used was a piece of re-bar and, judging by the hamon, had a carbon content similar to that of 1040 - 1050. I polished the blade using only waterstones and fingerstones. The habaki is made from 2mm copper sheet and has two thin grooves with file marks below and polished above. The saya has hand painte
×
×
  • Create New...