Jump to content

K Freier

  • Content Count

  • Joined

  • Last visited

Community Reputation

0 Neutral

1 Follower

Contact Methods

  • Website URL
  • ICQ

Profile Information

  • Gender
  • Location
    south east WI-USA
  • Interests
    bladesmithing lockpicking reading good books and being out doors

Recent Profile Visitors

761 profile views
  1. Not a beginner project, but make a lathe, and few more mills? Lucky guy you.
  2. The analogy that works for me is for the steel to look like melted butter,this is with the flux on.When looking into my coal forge I get the steel about the same color as the glowing coals.
  3. @ stewart I think that the reason they do the peening, is to work harden the iron, then sharpening is done, if at all.
  4. Use your forge as an anvil? All just because you can't find the tongs?
  5. Yep, cleared cookies and it works , Thanks for replying.
  6. The recent topics tab on the side of the main page doesn't show any new topics, and this is the feature I had previously used most. Was this intentionally dropped or is it just my computer.
  7. How did you do the blackening on the blade?
  8. I have a question, Do you pipe smokers think that the homegrown tobacco is healthier than the cigarrette type? Some of my relitives smoke, and I was wondering if it would be a safer step for them toward quitting if they were to use a pipe instead?
  9. K Freier


    Hows it flip? looks really good.
  10. What is the melting point of that alloy, and did you have to worry about heat transfering into the blade or charring your wood?
  11. I am Intrested in a Dvd also, what is the ball park figure for this 4 disk set?
  12. Ive got some questions about what happened on this special, The crucible you used for the Wootz, Did you make it your self? When you quenched, you pulled it out when it was still hot, especially the tang, Did you go to water or something to prevent the heat in the tang from creeping up into the blade? the bloomery iron was just leftovers from a run , or did you make that batch special for the show? I feel like they left out some important bits. Other than that Ric helped me educate my roomates, on how blade making works. Great Job!
  13. When you say cast, do you mean the 4% carbon stuff or Iron as in low carbon steel?
  14. Id like for my next big project to be an italian styled side sword, From what I understand its sometimes called a transition rapier,as a cut and thrust sword. Are there any specific points to try to hit,like blade witdth or lenght, weight, that would differentiate it from longsword ? Really what i am asking for is general guidelines on historic examples, which of course vary. Any input is appreciated.
  15. Sam, what the heck are you talking about?
  • Create New...