Search the Community
Showing results for tags 'drywall screw'.
I often mention using alignment pins and a drywall screw to hold the handle piece together while finishing the handle off the blade. I just did a search and realized I never posted the technique on this forum. So here it is. My alignment pins are laid out in relation to the tang, and I purposely offset them in relation to both center lines so that there is only one way to assemble the spacer to the handle once it is made. (pretend this spacer is not shaped yet)Now, the drywall (DW) screw will not fit through that slot. So, you have to grind off the teeth on opposite sides of the screw to make it thin enough to pass through the slot.Hopefully, your slot in the handle is not much wider than the slot in the spacer, but if it is (like this one) you will need some wood shim material. I use thin pieces of cedar shims from Home Depot.Slide them down the handle slot (fat end first) and break them off. They should be loose in the hole, but wide enough to overlap center.Now put your spacers or spacers & guard in place using the alignment pins.Slip a couple of washers over the screw, (put a leather one against the guard face so not to scratch it up), slip the screw through the slot and in between the wood shims. Tap it down until it is tight against the face and give it a 1/4 turn. It will hold everything together tightly.