Search the Community
Showing results for tags 'pneumatic hammer'.
-
Alright - so I was drawing out this multibar damascus billet today, I turn from the gas forge to the hammer - and what do ya know - the hammer is already out - even though I haven't even touched the damn thing... Next thing - the hammer slowly keep sliding further and further down until it eventually hits the anvil surface. I turn it off and open the cover over the rear piston - and test it by putting in some oil directly - and starting it again. It performs better - but still can't pull the hammer all the way up into it's chamber - and still slowly keeps falling down closer and closer to
- 38 replies
-
- powerhammer
- pneumatic hammer
-
(and 1 more)
Tagged with:
-
Greetings, gentlemen. One important question for you, please: My bladesmithing master installed power hammer in his shop - the type embedded in the floor in a deep pit, with proper cushioning (as per instructions). However, when it's put to work, the entire house is shaking - and since it's fairly old house, the end result is that he is unable to use the power hammer at all. It was quite costly, so we're trying to figure out what else can we do to be able to use it. Recently, my master came across notion of some kind of "pneumatic absorption pillows", that could possibly solve this pr
- 4 replies
-
- forging
- power hammer
-
(and 1 more)
Tagged with: