Search the Community
Showing results for tags 'regulator'.
Hello,- I'm working on putting together a forge and am looking at propane regulators. I don't know a ton about this stuff so bear with me. If I get a regulator like this, can I put a gauge down the line from it since there is no port on this particular regulator? How does one add a gauge to line? Can it simply screw into a T-Fitting of some kind? Help me shed some light on this conundrum. Thanks,
First off- I understand this isn't strictly about bladesmithing... however, I was working on metal when this problem arose... and blades are also made of metal... is this even the correct board? Apologies if there is a better location. I have been asking around and haven't found a straight answer yet to my question so I figured I would put it to others that likely also use oxy-acetylene torches. So, I was heating up a large piece of steel with a rosebud tip and seem to have broken the 1/7 rule. When I turned the torch off I immediately noticed the smell: acetone. I looked closer and noticed a reddish greasy liquid bubbling at the tip. Acetone seems to have been pulled up during the high pressure heating. Given that I now have gooey acetone in the regulator and hoses. I understand this is a BAD thing. But, my QUESTION is: how bad? is my acetylene diaphragm (and hoses?) slowly being eaten away and it's just a matter of time before I blow myself up? Is there any effective and safe way to clean this stuff out or do I need to re-build the regulator / buy a new one? I've asked a few people online and to my local machinist and their answers were sort of vague. Any advice that isn't vague? Thanks in advance, Eric
The attached picture is of my propane tank and the torch I have purchased. The system I am running is a forced air (hair dryer) forge. I have tested it out and it seems to work fine, I just want better efficiency so I can work longer. What I would like to know is what do i need as far as regulators go? Do I need a high pressure reg? Or a low pressure reg? I found a webpage from Don Fogg talking about the setup he recommends, using a high pressure reg at the tank and a low pressure reg with a needle valve and shut off close to the forge. Do I really need the low pressure reg? Or is it a preference thing? I'm almost positive that the torch itself is equipped with a needle valve and shut off so i don't need those. Also a general explanation of high vs low pressure as it relates to propane and forging would be nice as well (in lay terms, as some of the resources I have checked went over my head) Any and all help is appreciated!