Search the Community
Showing results for tags 'tang'.
Found 3 results
JamesK posted a topic in Beginners PlaceI first want to apologize for asking three questions so far on this blade, but I haven’t been able to find any good hidden tang making tips so I’ve been winging it and asking questions along he way. This is the best I was able to get, and it’s not that good, but any suggestions before I completely grind the blade and treat it? i know tang is awful but hopefully I can hide it enough and it won’t be an issue fitting it into the handle
Drawing out - keeping width
JamesK posted a topic in Beginners PlaceI've mentioned before in my other posts that the steel I use is sort of thick, like maybe 1/4", so not too much but for my case too thick to make a tang out of. I don't want to make a hidden tang as I prefer scales so I have to forge/grind out the shape in the metal. How would I draw out the steel for the tang in a way that I flatten it but don't change the width much? I would experiment but I'm low on steel and would like to ask before I potentially waste what I have left, so my guess is to hit one side, then turn 180 degrees to hit, then 90 degrees to flatten, is this a good strategy?
Beginner - Question about Tangs (for scales)
JamesK posted a topic in Beginners PlaceSo as a beginner with a very very cheap workshop, I don't really have the tools to make hidden tangs yet, as I don't have money or space for a drill press yet. Because of this I'm stuck to scales, which means I have to shape my tangs into what the handle will eventually look like. My issue is that my steel I use is thick and when I finish my blade and start my tang, the area for my tang is usually heavier, making the blade a bad balance. So I'm basically stuck with drawing out my tang to eventually have a flatter material. When I draw out my tang, how do I make sure that the metal for the tang stays through the midpoint of the knife so that when I eventually flatten the tang, part of it doesn't protrude either above or below the blade? I know this seems like kind of a stupid and obvious question, but it was an issue with one knife I made and I want to make sure I don't make this mistake again!