Search the Community
Showing results for tags 'Utility'.
-
A while back, a coworker of mine gave me some truck leaf springs, and I cut a piece to forge into a full-tang clip point EDC. Unfortunately, I overdid correcting a slight warp near the tip and snapped it off, so I rounded off the end and made it more of a utility knife. I feel like I did fairly well forging it close to shape, though, and didn't need much grinding on the blade. Of course, I also like forge finish and hammer marks--it's kind of my aesthetic :P. I also soaked it in vinegar overnight to give it a bit of a patina. The handle scales are red oak that I shaped, inspired by a Scandinav
- 3 replies
-
- neo-tribal
- utility
-
(and 1 more)
Tagged with:
-
I've been experimenting a lot with this material recently; someone saw one of the earlier Impregg handles I did and commissioned this guy. The fun part about this material is being able to forge these free-form blades and not have to worry about spending time on fitting scales to the tang. The thumb rest give great control over the edge and is more comfortable than jimping in my opinion. Comments and critique always appreciated Theo
-
Here is a small EDC knife for sale. It is made out of 5160 and has been precisely heated treated for this specific metal. It is 6.5" overall with a 3.5 inch blade. The tang is 1/4inch thick at the thickest then goes into a distal taper like all forged knives should! The handle wrap is tan Para cord. The blade was edge quenched (differential HT) properly normalized 3X, hardened in oil and tempered 3X for 2 hours at 370 degrees. for an extra 15 dollars I will make and include a leather sheath. Please let me know if you have any questions. I am asking $115 shipped + optional $15 for sheath. Vets,
-
Hi this is a beautiful full tang Tactical/Fighter forged out of Aldo's 52100. It is 1/4" at the thickest and gentle tapers with the distal taper. The blade overall length is 10" with a 6" blade and 4" handle. The wood is an exotic hardwood called bocote that has been hand polished, oiled and sealed. It has two 1/8" brass pins and has epoxied to hold everything together permanently. The blade has been differentially heat treated using Master Smith Ed Fowlers method. It has been 4x normalized, 3x hardened, and finally tempered 3x for 2 hours each time. Between each step it has been placed in the