Gyuri 0 Posted August 27, 2015 I think everyone knows the phenomenon. I wrote a short rant about it: https://makesg.wordpress.com/2015/08/26/the-painful-truth-about-blade-warping/ Now I'm curious: is it a daily issue for everyone? How much warpage is too much? Share this post Link to post Share on other sites
Austin_Lyles 139 Posted August 27, 2015 Never had the issue, although I usually work with small blades. I experiment a large amount with hamons with 1084 through the usual w2 quenching in peanut oil and brine. I have however noticed quite a bit of sori quenching in water with some of my larger forged w2 pieces. But that's expected. Share this post Link to post Share on other sites
Josh A Weston 35 Posted August 27, 2015 That's a nice article. I used a pro HT option for my first couple of years while I was still trying to get my bearing. Now I do a lot of my own but outside of axes I find the consistency was so much better when I used the HT. I don't really kick out enough quantity to make this a part of my process otherwise I would most certainly use a pro HT company. Share this post Link to post Share on other sites
Gyuri 0 Posted August 27, 2015 I'm still experimenting with this, but my method is to stock 10 or so blades from the same material, ready for HT. Then send them to the pr HT company. They charge for it by the kilogram, BTW Share this post Link to post Share on other sites
Sam Salvati 71 Posted August 27, 2015 the grace period above 400f is a major key to fixing any warps Share this post Link to post Share on other sites
