Jump to content
Sign in to follow this  
Viktor Johansson

Inlaying stones into soft metal using a dremel

Recommended Posts

Hello fellows,

Here is how I inlayed some synthetic corundum stones (ruby/sapphire) into a piece of copper for a knife handle. I don't know if you can call it tutorial but here is how I did it:

 

A slot was milled, tricky to make it fit right. Also the damn mill bit liked to fly around and make a mess of things. 

Milled slot 1.jpg

 

Then the outside of the slot was milled. But I quickly changed to files because it went faster and easier.

Milled slot 2.jpg

 

I found files worked much better to shape the outside, to create a collar around the stone.

Milled slot 3.jpg

 

Stone is ready to be set.

I set them by hammering the collar around the rim of the stone using a hammer and a rounded punch-tool.

Milled slot 4.jpg

Milled slot 5.jpg

 

Stones are now set and ready to be used for a knife handle in this case. 

Edited by Viktor Johansson

Share this post


Link to post
Share on other sites

if you use a pitch bowl, it will hold your copper work piece solidly and make life much easier

nice work!

Share this post


Link to post
Share on other sites

It would be easier to make a bezel and solder it to a piece of sheet,something with a little practice would only take 15 minutes or so.

Share this post


Link to post
Share on other sites
On 8/4/2017 at 10:23 AM, Greg Thomas Obach said:

if you use a pitch bowl, it will hold your copper work piece solidly and make life much easier

nice work!

You can also super glue it to a piece of plywood.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×
×
  • Create New...