Jump to content

Workshop setup.

Recommended Posts

After a rather long break from knife making due too life and other priorities getting in the way I’m finally setting up all my gear again.

However over my time off I have developed an elbow injury, a bone spur in my right elbow that is causing all sorts of grief. I have full function but reduced strength and it’s ok-ish most of the time, if I’m mindful of technique and ergonomics of tooling. But that has been a trial and error process with mixed results.

So I’m looking for a little advice on things like bench heights, grinder heights etc from people who have munted elbows....


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Create New...