Jump to content
Sign in to follow this  

Workshop setup.

Recommended Posts

After a rather long break from knife making due too life and other priorities getting in the way I’m finally setting up all my gear again.

However over my time off I have developed an elbow injury, a bone spur in my right elbow that is causing all sorts of grief. I have full function but reduced strength and it’s ok-ish most of the time, if I’m mindful of technique and ergonomics of tooling. But that has been a trial and error process with mixed results.

So I’m looking for a little advice on things like bench heights, grinder heights etc from people who have munted elbows....


Share this post

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

  • Create New...