Jump to content

Recommended Posts

I have access to the same overhead router pictured below.  It occurred to me that the body of this tool could possibly be used in the fabrication of an air hammer... the overhead motor and table assembly are easily removed to make way for anvil/cylinder etc.  Feedback/opinions are much appreciated.

 

Regards,
Alberto

router1.jpg

Link to post
Share on other sites

Thanks Geoff,

 

I agree, it is a shame however the unit has a motor issue which makes it not worthwhile as it is.  My thought is that it might be a good platform to start with, it weighs a lot and is extremely well built, it should be able to take the abuse and would save from having to fabricate a frame to start with.

 

Alberto

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...