Jaro Petrina 243 Posted December 30, 2020 Share Posted December 30, 2020 (edited) I have two long bars to weld, these are old wrought, I hope it goes well, because I havent tried this one yet. Then two fat ones they are 7 layer O1+15N20 to be welded, drawn and torded. And the edge bar is C45W, which I still might swap for something more hardenable in which case I would move this to be the back of the blade. This should be a little pocket massacre with over 10 mm thickness at the thickest point, so we shal see, for I had the tendency to overforge the thickness. Chance also is that I have altogether too much material in which case the knife will be bigger and the drawing conveniently lost in the process Cleaning of the surfaces took me better part of the afternoon. Edited December 30, 2020 by Jaro Petrina 1 Link to post Share on other sites
Shane Atwood 7 Posted January 4, 2021 Share Posted January 4, 2021 Looks super cool! Link to post Share on other sites
Jaro Petrina 243 Posted January 9, 2021 Author Share Posted January 9, 2021 All the bars are welded and drawn, tording is not perfect, but it will make a knife yet. A BIG ONE! Link to post Share on other sites
Jaro Petrina 243 Posted January 9, 2021 Author Share Posted January 9, 2021 In case anybody wonders I have welded and drawn 4 torsion billets. They can heat burgers too. 1 1 Link to post Share on other sites
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now