Jump to content

New Forge, WIP?


Seth Carpentier

Recommended Posts

Wayne, I appreciate the recommendation and have looked at your site. I was kind of leaning away from a ribbon burner because I was afraid it would be a little too complicated. 
 

However, I am intrigued and now considering building a ribbon burner. I think I’ll be in touch for some of your casting and a 1/4” needle valve. It’ll make me feel better getting it from you. 

Link to comment
Share on other sites

Don't overlook 

the Ribbon Burner attachments on the Forge Supplies page at

www.WayneCoeArtistBlacksmith.com.

Let me know if I can help you.

 

Thanks Seth, I look forward to hearing from you.

Wayne Coe
Artist Blacksmith
729 Peters Ford Road
Sunbright, Tennessee
706-273-8017
waynecoe@highland.net
www.WayneCoeArtistBlacksmith.com

Link to comment
Share on other sites

  • 1 month later...

Finally back at building the forge/burner. Life really gets in the way of these wonderful hobbies sometimes. I decided to go the ribbon burner route following instructions from Wayne’s page. I just have to cast it and get everything put together. I’ll attach a photo of the pipes. I have a lot of unnecessary length on them and will most likely lose a lot of them. I guess it just depends on my setup for the cart I’ll be using and how much length I end up needing. 

E275377B-02D7-49B5-93E3-F03F044DD711.jpeg

8BCE7182-0858-4FCB-864C-63E46A299A33.jpeg

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...